Instant Blog and Article Publish site
Laundry Chute
Business

How To Install A Laundry Chute

Laundry is an everyday activity. Some even call it an everyday issue. If you are one of those then you are likely to consider a laundry chute. When you have a laundry chute, you simply need to open your laundry chute discharge door and this will save your time and energy. You don’t have to go up and down stairs several times. If you are living in a two or three-story house and you don’t have a clothes chute, you already know that running from your bedrooms or bathrooms to the laundry room with multiple trips up and down-stairs is a headache. You don’t want to do this, right? And, you are also carrying a basket full of dirty towels and clothes. If you have a suitable location, you can easily install a laundry chute. It is super easy to install a laundry chute discharge door . Make sure that you have no obstructions between the floors.

If you are installing a laundry chute on your own, call a plumber if you are not aware of what could be in the way of the chute. There should be no obstacles like plumbing or wires. Your hallway is the best place for installation. Getting it installed will be a lot easier if the floor joints and the wall run parallelly. You can locate two studs by using a stud finder. You can check for obstructions by boring a small hole. 

You need the following supplies to install a laundry chute.      

  • Drill bit set
  • 4-in-1 screwdriver
  • Drywall saw
  • Drill/driver – cordless
  • Taping knife
  • Tape measure
  • Reciprocating saw
  • Utility knife
  • Tin snips
  • Drywall
  • Drywall tape
  • Drywall compound
  • Duct tape
  • Laundry chute discharge door
  • Sandpaper
  • Primer
  • Paint
  • Metal duct
  • Sheet metal screws

Once you have all the supplies, take the following steps: 

Open The Wall 

Be careful when you are opening the wall for chute installation. First of all, remove the baseboard. Cut a drywall 42 in. high chunk out using a utility knife down each stud’s center. Cut out the base plate using a handsaw and reciprocating saw. Be careful while removing the plate if it is nailed to the trim and the drywall. Make the required space for the duct through your plywood floor. The laundry door’s frame needs a nailing surface between the studs. So, install a 2X4 blocking piece at the top.       

Install the metal duct

Snap rectangular pieces of the duct together. Expand the opening in the 90° elbow by using metal-cutting snips. Keep in mind that it should be slightly smaller than the opening of the laundry door. Cut after trimming and folding over the opening flap. Now, install your laundry chute. Attach the duct to the studs on each side and the top blocking. Duct-tape the edges and joints to protect your clothes from sharp edges.

Leave a Reply

Your email address will not be published.

back to top